Metlsaw Model CS-4 Fully Automatic Programmable Non Ferrous Saw

Manufacturer

METLSAW

Stock

SAC54X

Model

CS-4

Dealer Location

Illinois

Spec Sheet

Max Dia. Blade - 28 inches
CNC Control - yes
Type of CNC Control - Allen Bradley DH485
Maximum Material Width - 48 inches
Maximum Material Thickness - 8 inches
Programmable Backgauge Range - 96 inches
Backgauge Speed - 0 - 200 IPM
Maximum Saw Blade Diameter - 28 inches
Cutiing Speed - Up to 500 sq.in/min (aluminum)
Carriage Feed Rate - 0 - 600 IPM
Blade Motor - 30 HP
Voltage - 480 volt 3 phase (80 amps)
Backgauge / Carriage Drive - DC Servo Motor
Air Requirements - 30 CFM


Allen Bradley DH485 PLC and Panelview 1000 programmable controller. Programmable precision backguage automatically feeds to 96” (maximum). Two sets of safety light curtains. Chip collector system.  Cuts solids, extrusions, tubes or rounds. Automatic fast forward blade travel. Universal clamping for single or bundle cutting. Variable cutting speed according to type & thickness of material. Servo controlled carriage drive provides smooth, finely controlled cutting speeds. Variable cutting lengths allow very small pieces to be cut as efficiently as large pieces. CRT display shows actual position of backgauge at all times. Automatic proportional speed control (automatically adjusts carriage traverse speed to thickness of material).


Cleaned, cycled, guaranteed to be in good working condition.

No Video Available

Want to request a quote from the owner of this listing?

Request a Quote