2” x 72” Technidrill Model 200-72-2.0-25-1BTA

Manufacturer

TECHNIDRILL

Category

Drilling Machines

Type

DRILLS, DEEP HOLE

Stock

HSD1179

Model

200-72-2.0-25-1BTA

Dealer Location

Illinois

Request a Quote
View Contact Information

Spec Sheet

Drilling Diameter, Maximum - 2”
Drilling Depth, Maximum - 72”
Chuck - 16” 3-Jaw
Hole Thru - 5”
Swing Over Ways - 12”
Spindle Speeds (Variable) - 300-2650 RPM
Spindle Horsepower - 30HP
High Pressure Coolant Pump - 25 HP
Electrics - 3/60/480 V
Approximate Drill Dimensions - 21” Length x 32” Width x 80” Height
Approximate Coolant System Dimensions - 60” Length x 32” Width x 82” Height


EQUIPPED WITH:
Tailstock with 5 HP Variable Speed Counter Rotation with 9-3/4” 3-Jaw Chuck and Controller for Tailstock Advance-Retract and Rotation.
Work Support Carriage with a 15-3/4” 3-Jaw Chuck with 5” Thru Hole and Pressure Head.
Operators Control Station with Spindle Pressure and Drill Monitor Load Meters.
Spindle RPM Display.
Spindle Variable Speed Controller.
Feed IPM Thumb Wheel Selector.
Manual and Automatic Operation Controls.
Manual Controls for Spindle Run. Pressure Head Return-Advance.
Tailstock Return-Advance.
Counter Rotation.
Manual Feed Advance-Retract.
Chip Conveyor Forward-Reverse.
Coolant.
Master Stop-Start.
Counter Rotation On-Off.
Emergency Retract.
25 HP High Pressure Coolant Filtration System with 5 HP Filter Pump that Removes Coolant from the bottom of the Settling Tank and Pumps it through Filters into the Clean Coolant Top Tank.
Free Standing Electrical Cabinet.
Coolant Kooler Chiller.
Chip Conveyor.

No Video Available

Want to request a quote from the owner of this listing?

Request a Quote